Two ways to connect LED
Flex Strip
(FSA-5M-300-12V-X
Models only): For
electricians install only.
Please refer to the enclosed instructions
with your shipment as
they have further important safety instructions
details.
Disconnect power before installing or using. All
installation and hook-up should be done in accordance with all
national and local electrical codes. |
| 1) Quick Connect (new): For
indoor type applications. Connection kit is not included. |
 |
Step A1: pull out the black clip
out gently and carefully .
Step A2: put the light strip into the space between the clip and connector .
Step A3: push the clip in original position to clap in.
If loose, redo. |
 |
Step B1: pull out the black clip of each side
gently and carefully .
Step B2: put the light strip in the space between the clip and connector at one side.
Step B3: put the light strip in the space between the clip and connector at the other side, and push the clip in original position.
|
| 2) Solder connection: |
| |
 |
| Make sure power supply is not
connected. Cut at the printed mark (only) with scissors to size. Place
end cap at end and secure with silicone glue. Allow to fully dry
before using. |
| |
| To attach wire at the cut
mark, solder leads on one side. The positive (+) and negative (-) is
printed on the product. Place end cap at end and secure with silicone
glue. Allow to fully dry before using. Make sure that the connection
points are protected against possible contact with conductive
material. |
| |
