Low Voltage Motion Sensors Switch LN-SPIR-1CH is an infrared low voltage detection sensor switch that use of infrared detection to turn on/off low voltage LED lighting (12/24VDC). As a person approaches the sensor within 16 feet (5 meter) area, the sensor acts as a switch to turn on the attached optional LED lighting. After a person leaves the sensor area, the Motion Sensors Switch will turn off automatically according to the set time delay (1 to 10 Minutes).
Note: For use only with Low voltage Class 2 Regulated LED Driver Models.
|Motion Sensors Switch (Human body infrared sensor)|
|Dimension: L76 X W35 X H34 mm (2.99″ x 1.37″ x 1.33″)|
|Detection distance area: 16 feet (5 meter)|
|Compatible 12/24VDC LED lighting fixture and class 2 regulated power driver|
Motion Sensors Switch Wiring Diagram
Directions for Use
|Turn power off before connecting lighting or power source. Please carefully check that the wire attached to the screw terminal are screwed in tight to avoid short-circuit between connecting wires|
|Use the setting knob at the back of the controller to set the delay time (1 to 10 Minutes) to turn off after a person is away from the area.|
|The controller signal output line and input line should be connected with the correct polarity. Do NOT exceed 5 amps of power source.|